Nilox DOC E-BIKE X3 Mode D'emploi page 8

EN
DISK AND BRAKE PAD CALIBRATION
The goal is to make sure that the brake disk is centrally
positioned in the calliper slot.
So turn the hex head socket screws (5 mm, using the
Allen key supplied) for calibration on the side of the
calliper.
Push the calliper laterally, try to turn the wheel and
ensure the brake pads do not touch the disk.
Once you have found the correct position close the
tightening screws. (8 Nm torque).
Turn the wheel and check again until you reach the
optimum position, in order to avoid their incorrect
wear, which would no longer guarantee full braking
efficiency.
ALWAYS TIGHTEN THE LOWER SCREW BEFORE
TIGHTENING THE UPPER SCREW.
With the calliper removed, you can check the brake
pads.
One pad is fixed, the other pad closes when the brake
lever is pressed.
The distance between the disk and the pads must not be
more than 3 millimetres and the pad must be parallel to
its disk.
Also ensure the brake pads are at the correct distance
(slightly more than the thickness of the disk) and are not
worn.
Otherwise the brake calliper would touch the disk during
braking, damaging it.
6