Replacing The Lamp; Closing The Door - Leonard LAI6001F Notice D'utilisation

Problem
The temperature in the ap‐
pliance is too low/too high.
If the advice does not lead to
the desired result, call the
nearest Authorized Service
Centre.

Replacing the lamp

The appliance is equipped with
a long-life LED interior light.
It is strongly recommended to
use original spare parts only.
Use LED bulbs (E14 base)
only. The maximum power is
shown on the lamp unit.
CAUTION! Disconnect the plug
from the mains socket.
1. Pull the left side of the lamp cover with
your fingers to unlock it. Remove the
cover by pulling it towards yourself.
Possible cause
The temperature is not set
correctly.
The door is not closed cor‐
rectly.
The food products' tempera‐
ture is too high.
Many food products are
stored at the same time.
The door has been opened
often.
There is no cold air circula‐
tion in the appliance.
2. Replace the bulb with one of the same
power and shape, specifically
designed for household appliances.
3. Install the lamp cover.
4. Connect the plug to the mains socket.
5. Open the door.
Make sure that the light switches on.

Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
installation instructions.
3. If necessary, replace the defective
door gaskets. Contact the Authorised
Service Centre.
Leonard 13
Solution
Set a higher/lower tempera‐
ture.
Refer to "Closing the door"
section.
Let the food products tem‐
perature decrease to room
temperature before storage.
Store less food products at
the same time.
Open the door only if neces‐
sary.
Make sure that there is cold
air circulation in the appli‐
ance. Refer to "Hints and
Tips" chapter.
1
2
1