Assembly Of The Kebbe Cap - Springlane Frida Mode D'emploi

ASSEMBLY OF THE KEBBE CAP

7
10
1. Hold the mincer's case (3) with the largest opening facing towards the top.
2. Put the screw (4) into the case.
3. Place the cap (8) and the short lens tube (10) in front of the screw. Seize the
lock (7) until the kebbe cap is fixated.
4. Hold the assembled mincer with the opening facing to the top and the kebbe
cap towards you. Connect it to the stand mixer's engine top via turning. The
large opening faces towards the top when assembled.
5. Put the funnel (2) onto the mincer.
8 4
2
3
15