General Information - Phoenix Mecano RK ROSE+KRIEGER Transformateur 120 VA MBL Notice D'assemblage

2.1 Information on these assembly instructions
These assembly instructions are only applicable to the transformer controller 120 VA described
and are intended as documentation for the manufacturer of the end product in which this trans-
former controller 120 VA is incorporated.
We wish to point out explicitly that the manufacturer of the end product must produce operating
instructions for the end user which includes all the functions and hazard warnings of the end pro-
duct.
This also applies to the installation in a machine. In this case, the manufacturer of the machine is
responsible for the relevant safety equipment, checks, monitoring potential crushing and shea-
ring points and for the documentation.
These assembly instructions will help you,
•
to avoid hazards,
•
to prevent down time,
•
and to guarantee and increase the working life of this product.
Hazards warnings, safety regulations and the information in these assembly instructions are to be
observed under all circumstances.
These assembly instructions are to be read and applied by all persons that are working with the
product.
Commissioning is forbidden until the machine complies with the provisions of EC Directive 2006/
42/EC (Machinery Directive). Before placing on the market, this must comply with EC directives,
including documentation.
We hereby inform any re-user of this transformer controller explicitly of its obligation to expand
and complete this documentation. In particular, when installing or attaching electrical compon-
ents and/or drives, the re-user is to complete a CE declaration of conformity.
Our declaration of incorporation becomes invalid automatically.

2. General information

19