Belden Hirschmann OZD Genius G12 Serie Mode D'emploi page 5

Safety Guidelines Environment
z
Warning!
The device may only be operated in the listed ambient temperature range at the listed relative air humidity (non-
condensing).
The installation location is to be selected so as to ensure compliance with the climatic limits listed in the Technical
Data (see page. 10).
To be used in a Pollution Degree 2 environment only (IEC 60664-1).
Note on CE identification
7
The devices comply with the regulations of the following European directive:
89/336/EEC
Council Directive on the harmonization of the legal regulations of member states on electromagnetic compatibility
(amended by Directives 91/263/EEC, 92/31/EEC and 93/68/EEC).
The EU declaration of conformity is kept available for the responsible authorities in accordance with the above-mentioned
EU directives at:
Hirschmann Automation and Control GmbH
Stuttgarter Strasse 45 – 51
72654 Neckartenzlingen
Germany
Telephone +49 (0) 1805 14-1538
E-mail HAC.Support@Belden.com
RELEVANT FOR USE IN NORTH AMERICA:
THESE DEVICES ARE OPEN-TYPE DEVICES THAT ARE TO BE INSTALLED IN AN ENCLOSURE SUITABLE FOR THE
ENVIRONMENT.
THIS EQUIPMENT IS SUITABLE FOR USE IN CLASS I, DIVISION 2, GROUPS A, B, C AND D OR NON-HAZARDOUS
LOCATIONS ONLY.
WIRING MUST BE IN ACCORDANCE WITH CLASS I, DIVISION 2 WIRING METHODS AND IN ACCORDANCE WITH THE
AUTHORITY HAVING JURISDICTION.
FOR USE IN CLASS I DIVISION 2 HAZARDOUS LOCATIONS REFER TO THE CONTROL DRAWING NO. 000100622DNR
ON THE NEXT PAGE.
FCC RULES
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This equipment gen-erates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio
communications. Operation of this equip-ment in a residential area is likely to cause harmful interference in which case
the user will be required to correct the interference at his own expense.
C-Tick
Australia / New Zealand
This product meets the requirements of the AS/NZS 3548 standard.
N1337
5