Startup Information; General Safety Instructions - Belden Hirschmann OZD Genius G12 Serie Mode D'emploi

Startup Information

OZD Genius G12 ...
Please read and notice the detailed
"Manual Fiber-Optic Repeater OZD Genius G12 ...".
Use the fax form on page 8 of this leaflet to order a free copy of this operation manual (Order No. 933 989-901).

General Safety Instructions

This device is electrically operated. Adhere strictly to the safety requirements relating to voltages applied to the device
as described in the operating instructions!
Make sure that the electrical installation meets local or nationally applicable safety regulations.
z
Warning!
Failure to observe the information given in the warnings could result in serious injury and/or major damage. Only
personnel that have received appropriate training should operate this device or work in its immediate vicinity. The
personnel must be fully familiar with all of the warnings and maintenance measures in these operating instructions.
Correct transport, storage, and assembly as well as careful operation and maintenance are essential in ensuring
safe and reliable operation of this device.
Never start operation with damaged components!
z
Warning!
Any work that may have to be per formed on the electrical installation should be performed by fully qualified
technicians only.
z
Warning!
OZD Genius G12:
LASER RADIATION
CLASS 1M LASERPRODUCT in accordance with IEC 60825-1 (2007).
OZD Genius G12-1300:
CLASS 1 LASERPRODUCT in accordance with IEC 60825-1 (2007).
Certified usage
Please observe the following:
z
Warning!
The device may only be employed for the purposes described in the catalog and technical description, and only in
conjunction with external devices and components recommended or approved by Hirschmann. The product can
only be operated correctly and safely if it is transported, stored, installed and assembled properly and correctly.
Furthermore, it must be operated and serviced carefully.
Safety Guidelines Power Supply
Switch the basic devices on only when the housing is closed.
z
Warning!
The devices may only be connected to the supply voltage shown on the type plate. The devices are designed for
operation with a safety extra-low voltage.Thus, they may only be connected to the supply voltage connec tions and
to the signal contact with PELV circuits or alternatively SELV circuits with the voltage restrictions in accordance
with IEC950/ EN60950/ VDE0805.
Relevant for North America:
The subject unit is to be suppplied by a Class 2 power source complying with the requirements of the National Electrical
Code, table 11(b). If power is redundant supplied (two individual power sources) the power sources together should
comply with the requirements of the National Electrical Code, table 11(b).
Use 60/75°C or 75°C copper(Cu) wire/conductor only.
Hirschmann. Simply a good Connection.
DO NOT VIEW DIRECTLY WITH OPTICAL INSTRUMENTS