Assembly; How To Use; General Information; Jacking Up - Rothewald 10031484 Mode D'emploi

5 | Assembly

2
4
7
6
1
3
5
The motocross paddock stand (1) is supplied pre-assembled. Only the foot lever (2) still needs to
be attached. Screw the end of the foot lever (2) to the middle column of the paddock stand with an
M8 bolt (4). Use the two longer M8 bolts (5) and the two articulated struts (3) to fit the foot lever
(2) to the welded-on mount for the paddock stand base. Place a washer (6) with the suitable inside
diameter under the screw head, under the nut (7) and one each to the left and right between the
components.

6 | How to use

6.1 | General information

Before using the paddock stand, it is imperative that you check whether the motorcycle meets the
basic requirements for being jacked up with the paddock stand. The maximum lifting capacity is
150 kg (including any accessories on the motorcycle). It is designed for a ground clearance of no
less than 30 cm and no more than 38 cm. The rubber pad protects the vehicle from scratches.
We recommend loosening any tight screws (axle nuts etc.) on the vehicle before jacking it up.

6.2 | Jacking up

Position the paddock stand centrally under the lower frame tubes, ensuring that the contact area on both
sides is sufficiently large. Therefore, first check whether the lower frame tubes are freely accessible.
IMPORTANT!
Risk of damage!
Please bear in mind that protruding parts, such as floor pans, engine parts,
plastic parts, exhaust or manifold systems are not suitable contact surfaces for
the stand.
14