Menu Button; Set Date And Time - Trevi RC 80D2 DAB Manuel Utilisateur

POWER THE UNIT
AC POWER
Plug the AC adaptor into a power outlet and the jack of the adaptor into the
DC Input Socket (on the back side of unit).
BATTERIES
Insert 4 AA batteries (not included) into the battery compartment on the underside of the unit,
respecting the indicated polarity (positive of the battery on the pin contact, negative of the
battery on the spring contact).
Note: when inserting the batteries, remove the AC adapter from the power outlet.
During battery operation, with the device in standby, the display is turned off to safeguard battery
consumption. To turn the display back on and view the current time, press the SNOOZE / SLEEP
button (10). The alarm alarm function is always active even with the display off, if programmed,
the alarm will work by activating the alarm set as described in the relevant paragraph.
On the display at the top right there is an icon that shows the charge level of the batteries, replace
them when the level indicated is low (one notch).
With batteries running low, some malfunctions are possible such as changes in the brightness
of the display or general malfunctions of the device; in these cases, replace the flat batteries.
In the event of blockages or malfunctions of the device, perform a reset by disconnecting the
adapter and removing the batteries for about 5 minutes.

MENU BUTTON

When the unit is in standby mode, press and hold the Menu Button for about 2 seconds
and then release the button. Press Up/Down Button repeatedly to select the following :-
1) Set Time/Date
2) Blacklight
3) Language
4) Factry Reset
5) SW Version
Press Select Button to confirm your selection. Under each selection, press Up/Down Button
and Select Button for each setting.

SET DATE AND TIME

1. Press and hold the Menu Button for about 2 seconds and then release the button.
Press Up/Down Button repeatedly until "Set Time/Date" is displaying. Press once the
Select Button to enter Time/Date setting mode.
2. Press Up/Down Button to select Set Time, Set Date or Auto Update mode and press
Select Button to make selection.
3. Under each selection, press Up/Down Button and Select Button to make every
selection. Press and hold the Menu Button for about 2 seconds (or wait for about 5
seconds without pressing any button) to complete the DATE AND TIME setting.