Axis Q60 Serie Guide D'installation page 24

AXIS Q60 Series
• To install the power supply (sold separately) and the supplied media converter switch, see
page 25.
• To install the network camera using a compatible bracket from AXIS T91A Mounting
Accessories (sold separately), see Install the Network Camera.
Replace the Dome Cover
Replacing the dome cover is only necessary if you want to use a smoked dome cover or if the
dome cover is scratched or damaged. Smoked dome covers and spare clear dome covers can be
purchased from your Axis reseller.
1. Loosen the dome ring screws and remove the dome cover.
2. Remove the dome bracket screws and remove the dome bracket and the dome cover
from the dome ring.
3. Make sure the rubber gasket is fitted correctly on the dome cover.
4. Align the bulge on the dome cover with one of the logotypes on the dome ring.
5. Attach the dome bracket and the dome cover to the dome ring and tighten the screws
(torque 1.2 Nm).
6. To install an SD card (not included), see Install an SD Card on page 25.
7. To attach the dome cover to the top cover, align the bulge on the dome cover with the
cooling system on the camera unit and tighten the screws (torque 1.5 Nm).
24