After Use; Transport - Rowenta IS6200 Mode D'emploi

Crease attachment
• Remove the fabric brush. Completely slide the
hook of the accessory into the slot located in the
lower part of the steam head.
• Push on the handle to open the crease attach-
ment.
• Place the garment between the crease attachment
and steam head.
• Release the handle.
• Starting at the top of the garment, move the crease attachment in a downwards motion.
• Once unit is unplugged and completely cooled down, remove the crease attachment
by sliding it off of the steam head.
Lint pad
The lint pad is a separate accessory and cannot be attached to the steam head.You
can use the lint pad independently from the steamer.
• The lint pad removes hair, lint and animal fur for a professional finish.
• To use the lint pad, slowly brush the clothing with the grain or nap of the fabric.
• The pad can be cleaned by brushing it in the opposite direction. We recommend clea-
ning the pad on an old cloth that can be discarded.

AFTER USE

• After using the garment steamer, switch off the appliance by pressing the pedal once
again. The power indicator light will go off, and you can then unplug the appliance.
• Hang the steam head in an upright position on the hook when not in use.
• Empty and rinse the water tank each time before storage in order to flush out any scale
particles. (fig.15)
• Loosely wind up the electrical cord and close with the Velcro strip, then hang it from the
clip on the handle. (fig.16a, 16b)
• Do not carry the steamer by the water tank handle. This appliance includes luggage
style wheels for added convenience when transporting.
Warning: Never touch the head until it has cooled down completely.

TRANSPORT

• Your appliance is fitted with two wheels for ease of transport. Tilt the appliance towards
the rear holding the handle and then pull along to transport.
• You can also lift up the appliance in order to transport it, again holding the appliance by
the handle.
Do not attempt to lift up or transport the device holding the pedal, the water tank
handle or the built-in hanger.
CLEANING
• Clean the main unit with a damp cloth.
• To maintain maximum performance, your steamer must be descaled occasionally. The
time between descaling operations depends on the quality of the water and the fre-
15
EN
EN
DE
NL
IT
ES
PT
SV
EL
TR
RU
UK
PL