Removing The Seatcover - CYBEX TWINYX Mode D'emploi

12. REMOvING THE SEATCOvER

a)
• Slightly fold the stroller to reduce tension.
• Remove the canopy from the stroller, if
attached.
• Remove the seat cover hooks (3) from
both sides of the frame.
• Open the press buttons (4) of the two
straps connecting the seat side panels
with the rear tube.
• Open the flaps (5) which are fixed with
velcro covering both sides of the seat
tube fixed underneath the seat unit.
• Feed the strap with the slider (6) of the
central harness buckle through the hole
in the seat fabric.
• Feed the loops at the end of the shoulder
straps through the triangle in the backrest
(7).
• Feed the shoulder straps through the holes in the seat fabric (8).
• Open the press buttons on the left and the right side of the seat unit. These are fixed at
the underside of the seat unit.
• Pull the seat cover over the harness adjustment button of the seat.
• Slide the fabric from the seat base tubes.
• Reverse this procedure to refit the seat cover and the harness. Make sure that the seat
tubes slide back into the pockets inside the seat cover.
35