CYBEX TWINYX Mode D'emploi page 27

II.-I CHECK OF WHEEL SYSTEMS
a) Wheel system must be cleaned before applying the lubricant.
b) Wheel system must not be broken or damaged. To avoid squeaking noises on your CYBEX
buggy only use WD 40 and follow the instructions below. Do not use any other kind of
lubricant! Before applying the lubricant, in order to avoid any stains on the fabrics, please
protect them by holding a cloth or carton in front of them. Please pay special
attention to not apply the lubricant on any other part of the stroller (fabrics, tubes, etc.).
II.-II APPLYING OF THE LUBRICANT
a)
Rear wheel – Spray from the rear side of the buggy in the
space between the rim and the housing on both sides. Let the
lubricant work its way into the system for approx. 10 seconds
and then turn both rear wheels.
b)
Front wheel – Spray in the space between the rim and the
housing on both sides. Let the lubricant work its way into the
system for approx. 10 seconds and then turn both front wheels.
Should this not avoid the squeaking, please remove the rim cap
and apply the spray on the axle.
c)
Suspension – Apply some lubricant between the suspension
slider and the housings.
27