Tectro TP 1020 Manuel D'utilisation page 71

Insert the plug into the wall outlet.
Press the -button to switch on the air conditioner. The air conditioner
starts in the automatic mode:
• If the ambient temperature is higher than 23ºC, the unit will work in
cooling mode.
• If the ambient temperature is < 23ºC, the unit will work in air circulation
mode.
With -button you can change the operating mode of the unit.
By pressing the -button the following modes appear:
Automatic mode
Cooling mode
Air circulation mode
COOLING
When the unit is in the cooling mode, the following functions apply:
• The fan speed can be adjusted by pressing the
Maximum setting.
Lowest setting.
• The temperature can be set by pressing the
between 18°C en 32°C. The display will show the set temperature for 8
seconds and the "set temp" will light up. Fifteen seconds after setting
the required temperature, the display will show the room temperature.
In auto mode, the unit will choose the ventilation speed automatically
according to the ambient temperature. The speed switch cannot be
changed in this mode.
G
It depends on the environment whether the required temperature will
be reached. It is not a malfunction of the air conditioner if the room
temperature remains above the "set temp". It could well be that the
heat load of the room is too much.
DEHUMIDIfyING
The air can also be de-humidified with this device:
1. Select the cooling function
2. Select the lowest ventilator speed with the
3. Select a low temperature (e.g. 16ºC) with the
4. Do not connect the de-aeration hose
5. Connect the fixed water drainage hose (see chapter G) and lead the hose to a
water drain. Ensure that the water drainage hose runs downhill for its entire
length.
The air conditioner will now de-humidify as long as the room temperature
is above the set value. The device will be unable to de-humidify if the room
temperature drops below the set value.
-button
and
with the button
button
button
buttons, anywhere
4
71