Navigate In The Menu; Clear Stored Values Automatically (Aclr) - Seca 959 Mode D'emploi

Navigate in the menu

tare
tare
Clear stored values
automatically (AClr)
1. Switch on the scales.
2. Hold down the arrow key (bmi/menu) until the
menu is called up.
The last menu item selected is shown in the display
(here: Autohold "Ahold").
3. Keep pressing one of the arrow keys until the re-
quired menu item appears in the display (here: at-
tenuation "Fil").
4. Confirm your selection with the Enter key (send/
print).
The current selection for the menu item or a sub-
menu is displayed (here level "0").
5. To change your selection or call up another sub-
menu, keep pressing one of the arrow keys until the
required selection is displayed (here: level "2").
6. Confirm the selection with the Enter key (send/
print).
You will leave the menu automatically.
7. To make further selections, call up the menu again
and proceed as described above.
NOTE:
If no key is pressed for approx. 24 seconds, you
will leave the menu automatically.
To avoid storing obsolete measured results in the
device memory and so calculating the BMI incorrectly,
you can set the scales to ensure measured values are
automatically cleared after 5 minutes.
NOTE:
With certain models this function is already acti-
vated at the factory. If required, you can disable
this function.
1. Select the item "AClr" in the menu.
2. Confirm the selection.
3. Select the setting you require:
– On
– Off
4. Confirm the selection.
You will leave the menu automatically.
English
Operation • 73