Oscillation Function - purline HEATY 126 Manuel D'utilisation

desired temperature and counter-clockwise to
decrease the desired temperature.
3. The desired temperature can be set between
15° C and 30° C.
4. When the air temperature reaches 2 degrees
above the set temperature, the heater will
stop heating at once and stop blowing after
15 seconds.
5. When the air temperature drops 1 degree
below the set temperature, the unit will come
back on.
Note: It is normal for the heater to cycle ON and
OFF as it maintains the set temperature.

OSCILLATION FUNCTION :

This function will work in any mode. Pressing the
oscillation button (OSC) will allow the heater to
oscillate back and forth. To stop the oscillation,
press the oscillation button once more.
SAFETY FEATURES WITH ALARM
This heater includes an audible alarm to warn
that parts of the heater are getting excessively
hot. If the alarm sounds, immediately turn the
heater off and inspect for any objects on or
adjacent to the heater that may cause high
temperature.
25
DO NOT OPERATE THE HEATER WITH THE
ALARM SOUNDING.
1. Wait 15 minutes for the unit to cool down.
2. After the 15 minutes, plug the unit in again
and operate normally.
MAINTENANCE
WARNING: ALWAYS UNPLUG THE CORD
BEFORE MOVING OR SERVICING.
DO NOT IMMERSE HEATER IN
WATER.
CLEANING: Clean the heater at least once a
month, more often if dirty.
Clean the heater grill with the vacuum brush
attachment on your vacuum cleaner. This will
remove lint and dirt from the inside of the heater.
Do not attempt to take apart the heater.
Do not remove grill guard or allow heater to be
operated without grill guard in place.
Clean the body of the heater with a soft cloth.
(NEVER USE ALCOHOL OR SOLVENTS.)
STORAGE: Store the heater with these instructions
in the original carton in a cool, dry place.
Characteristics prone to change without notice.
WARRANTY:
The warranty is valid for 2 years for a « manufacturing fault ».
26