Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
1. Carefully remove the heater from the carton and
the bag.
2. Make sure that the heater is in the "OFF"
position before plugging the heater into an
Outlet.
3. Place the heater on a firm, level surface
4. When the heater is initially plugged in and turns
on the power switch on the rear of the unit, there
will be a « beep » and the power indicator will be
on indicating that there is power to the unit. The
indicator will remain lit until the power switch on
the rear of the unit is turned off.
5. Turn the heater on by pressing the "Power &
Mode" button.
6. Upon turning the heater on, the unit will be in the
LOW heat mode (1100 watts), the « LO » and
current room temperature will be displayed on
LED circularly during 5 seconds.
7. Pressing the " Power & Mode " button at this
point will set the heater into the HIGH heat mode
(1800 watts), the « HI » and current room
temperature will be displayed on LED circularly
during 5 seconds.
8. Pressing the "Power & Mode" button at this
point will set the heater into the AUTO mode
(1800 watts). The LED will display the default
temperature of 25° C flickeringly. Notice that now
23
you can set the desired temperature by the
thermostat knob. (See thermostat instruction). If
you do not set the temperature in 3 seconds, the
LED will stop blinking and will display the "AU"
and current room temperature circularly during
5 seconds.
9. Pressing the "Power & Mode" button once more
will set the heater into the FAN mode (15 watts).
The "FA" and current room temperature will be
displayed on LED circularly during 5 seconds.
Fan mode is only for fan operation, without any
heat output.
Pressing the "Power & Mode "button again and the
heater will go back to LOW heat mode. Continuing
to press the button will cycle the unit through LOW,
HIGH, AUTO, FAN mode.
To cut off the unit, press the "Power & Mode"
button and hold 2 seconds.
Do the same to turn the heater off, then turn off the
power switch and remove plug from power outlet.
WARNING: METAL MESH IS HOT WHEN
HEATER IS IN OPERATION.
THERMOSTAT INSTRUCTION :
1. Press the "Power &Mode "button until the
heater is set into the AUTO mode.
2. To adjust set temperature, rotate the
Thermostat knob clockwise to increase the
24
Publicité
Table des Matières
