Télécharger Imprimer la page

purline HEATY 126 Manuel D'utilisation page 10

Chauffage ceramique soufflant avec thermostat et ventilation

Publicité

Les langues disponibles
  • FR

Les langues disponibles

2. Make certain that the power source conforms
to the electrical requirements of heater
(AC220-240V ~ 50Hz).
3. The appliance is not intended for use by
young children or infirm persons without
adequately supervision; Young children
should be supervised to ensure that they do
not play with the appliance.
4. To reduce the risk of electric shock, this plug
is intended to fit in a correct outlet. If the plug
of heater does not fit fully in the outlet,
contact a qualified electrician.
5. Where possible, avoid the use of extension
cords because the extension cord may
overheat and cause a fire. However, if you
have to use an extension cord, the cord shall
be a 2-wire, with minimum 1.0mm² or larger
and rated not less than 1890 watts. Never
use a single extension cord to operate more
than one heater.
6. Do not operate heater with a damaged cord
or plug or after the heater malfunctions, has
been dropped or damaged in any manner.
Return heater to authorized service facility for
examination, electrical or mechanical
adjustment or repair. If the supply cord is
damaged, it must be replaced by the
manufacturer or its service agent or a
similarly qualified person in order to avoid a
hazard.
19
7. Close the power switch and unplug power
cord before servicing or moving the heater.
Always unplug heater when not in use.
WARNING: DO NOT DEPEND ON THE
ON/OFF BUTTON OR SWITCH AS THE SOLE
MEANS OF DISCONNECTING POWER WHEN
SERVICING OR MOVING THE HEATER.
ALWAYS UNPLUG THE POWER CORD.
8. Do not insert or allow fingers or foreign
objects to enter any ventilation or exhaust
opening as it may cause an electric shock or
fire or damage the heater. Do not block or
tamper with the heater in and manner while it
is in operation.
9. To prevent a possible fire, do not block air
intakes or exhaust in any manner. Do not
place heater on soft surfaces, like a bed
where openings may become blocked.
10. Always place the heater on a stable, flat,
level surface when operating, to avoid the
chance of the heater overturning. Locate the
power cord so the heater or other objects are
not resting on it. Do not run power cord under
carpeting. Do not cover power cord with
throw rugs, runners, or the like. Arrange
power cord away from room traffic and where
it will not be tripped over.
11. This heater is hot when in use. To avoid
burns, do not let bare skin touch hot surfaces.
Always use handle when moving this heater.
20

Publicité

loading