Panasonic DoubleFeature OmniVision VHS PV-D4743S-K Manuel D'utilisation page 37

* Important: if a remote control button does not work when pressed,
When appears on the screen while
a button is being operated, it means
that the corresponding operation is
prohibited by DECK or the disc.
ANGLE Indicator
Notes
• The ANGLE Indicator lights up on
DECK when a scene recorded at
different angles is detected.
• The angle number can be set
beforehand so that the angle is
switched whenever the ANGLE
Indicator lights up.
SELECT
SET
ZOOM
SUB TITLE
ANGLE
AUDIO
Notes
• The subtitle cannot be enlarged nor
can it's position be changed.
• The picture zoom feature does not
work with a Video CD.
• During picture zoom, "ZOOM1" or
"ZOOM2" appears on-screen for 5
seconds.
• Zooming, on some discs, may result
in poor picture quality, or may not
operate at all.
PV-D4743S-K P36-56 (030223) RAM.p65
press the DVD button on the remote and try the button again.
Multiple Angle Viewing (DVD only)
DVDs may contain scenes shot from multiple camera
angles allowing the same scene to be viewed at different
angles. You can view these angles, if available, using the
ANGLE button.
1
SELECT :
2
SELECT :
Number of angle being played back.
Note
This function not available with DVD-RAM.
Vocal Selection for Karaoke Discs
1
Press AUDIO in Play mode
to display the audio screen.
2
SELECT :
END : AUDIO
• DVD Karaoke (1 vocal) VOCAL ON
• DVD Karaoke (2 vocals) VOCAL V1 VOCAL V2 VOCAL V1+V2 VOCAL OFF
• Video CD LR
Picture Zoom (DVD only)
You can enlarge specific portions of a picture and
select the zoom ratio using the ZOOM button during
DVD playback.
Press ZOOM repeatedly to change display
as follows.
• You can enlarge the center portion of the image
to one of 2 magnifications.
I Use the
, , and
up, down, left and right.
37
Press ANGLE
in Play mode to display the
angle selection on-screen.
• Display disappears after
5 seconds.
Press
to select the desired
angle.
(DVD/Video CD)
Press (or )
to select as shown below,
and
press (or ) to set.
(DVD only)
VOCAL OFF
L R
buttons to move the position
2003/03/14, 10:34
37