Napa PROFESSIONAL LIFTING EQUIPMENT 791-6420 A Manuel De Fonctionnement
Napa PROFESSIONAL LIFTING EQUIPMENT 791-6420 A Manuel De Fonctionnement

Napa PROFESSIONAL LIFTING EQUIPMENT 791-6420 A Manuel De Fonctionnement

3.5 tonnes métriques cric utilitaire professionnel

Publicité

Les langues disponibles

Les langues disponibles

Liens rapides

this operAting MAnUAl contAins
iMportAnt sAfety inforMAtion.
reAd cArefUlly And UnderstAnd
All inforMAtion before operAting
this deVice. sAVe this MAnUAl for
fUtUre Use.
owner/User responsibility
The owner and/or user must have an understanding of
the man u fac tur er's operating in struc tions and warn ings
be fore using this service jack. Personnel involved in
the use and op er a tion of equip ment shall be careful,
com pe tent, trained, and qual i fied in the safe operation
of the equip ment and its proper use when servicing
motor vehicles and their com po nents. Warning
in for ma tion should be em pha sized and un der stood.
If the operator is not fluent in English, the
man u fac tur er's in struc tions and warn ings shall be read
to and dis cussed with the op er a tor in the op er a tor's
native language
by the pur chas er/own er, mak ing sure the op er a tor
com pre hends its con tents.
Owner and/or user must study and maintain for future
ref er ence the manufacturer's instructions. Owner and/or
user is responsible for keeping all warning labels and
instruction manuals legible and intact. Replacement
labels and literature are available from the
manufacturer.
SPECIFICATIONS
Low Height . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4"
Raised Height . . . . . . . . . . . . . . . . . . . . . . . 20-1/2"
Length . . . . . . . . . . . . . . . . . . . . . . . . . . . . 28-1/2"
Chassis Width . . . . . . . . . . . . . . . . . . . . . . . 6-1/2"
Chassis Width with
Swivel Caster Bracket . . . . . . . . . . . . . . . . . 14-1/4"
Handle Length . . . . . . . . . . . . . . . . . . . . . . . . . 50"
Saddle Diameter . . . . . . . . . . . . . . . . . . . . . . 5-1/2"
Shipping Weight . . . . . . . . . . . . . . . . . . . . 105 .6 Lbs
791-6420 A
• Read, study, undeRstand and follow all instRuctions
befoRe opeRating this device. • inspect the jack befoRe
each use. do not use jack if damaged, alteRed, modified,
in pooR condition, leaking hydRaulic fluid, oR
unstable due to loose oR missing haRdwaRe oR paRts.
make coRRections befoRe using. • lift only on aReas of
the vehicle as specified by the vehicle manufactuReR.
• weaR eye pRotection that meets ansi Z87.1 and
osha standaRds. • do not use jack beyond its Rated
capacity. • this is a lifting device only. immediately
afteR lifting, suppoRt the vehicle with jack stands
capable of sustaining the load befoRe woRking on the
vehicle. • use only on a haRd level suRface fRee fRom
obstRuctions so the jack is fRee to Reposition itself
duRing lifting and loweRing opeRations. • centeR
load on saddle. be suRe setup is stable befoRe woRking
on vehicle. • do not move oR dolly the vehicle while
on the jack. • do not use saddle adapteRs oR saddle
extendeRs between the stock lifting saddle and the
load. • do not use any adapteRs unless appRoved oR
supplied by napa. • always loweR the jack slowly and
caRefully. • failuRe to heed these maRkings may Result
in seRious oR fatal peRsonal injuRy and/oR pRopeRty
damage.
1
Model # 791-6420 A
3.5 Ton CapaCiTy
professional
serviCe jaCk
WARNING
Revised 04/08/09

Publicité

Table des Matières
loading

Sommaire des Matières pour Napa PROFESSIONAL LIFTING EQUIPMENT 791-6420 A

  • Page 1 • do not use any adapteRs unless appRoved oR supplied by napa. • always loweR the jack slowly and Saddle Diameter . . . . . . . . . . . . . . . . . . . . . . 5-1/2"...
  • Page 2: Preventative Maintenance

    operAting MAnUAl & pArts list for 791-6420 SETUP PLEASE REFER TO THE EXPLODED VIEW DRAWING IN THIS MANUAL IN ORDER TO IDENTIFY PARTS. 1. Remove the 2-piece handle from box. Insert narrow portion of top section (13) into bottom section (15) and secure with bolt (14) provided.
  • Page 3 Pump the handle rapidly several times to push oil past ball valves in power unit. 5. Unit still does not operate. Contact an authorized service center from enclosed list. WARRANty Please contact your local NAPA Auto Parts Store for details on warranty. 791-6420 A Revised 04/08/09...
  • Page 4 operAting MAnUAl & pArts list for 791-6420 Index Part Index Part Description Qty. Description Qty. RS35T01 Retaining Ring RS35T20N Handle Bumper RS35T02 Washer RS35T13 Set Screw - Handle RS35B03 Front Wheel RS35B16N Handle Yoke Side Plate Assembly RS35T18 Universal Joint Assembly RS35B10 Rear Caster Assembly RS35B20N...
  • Page 5 operAting MAnUAl & pArts list for 791-6420 791-6420A Power Unit RS35B20N Index Part Index Part Description Qty. Description Qty. Steel Ball 5 RS0FS37 Screw (incl. #22 o-ring) Large Pump Housing O-Ring 7.1 x 1.8 O-Ring 15 x 2.65 Relief Valve Bolt Back-Up Washer 20 x 15.6 x 1.25 Relief Valve Spring Big Pump Piston...
  • Page 6 • siempRe baje el gato lentamente y con cuidado. Diámetro de la silla . . . . . . . . . . . . . . . . . . . . .5-1/2"...
  • Page 7 MAnUAl del fUncionAMiento y listA de pieZAs pArA 791-6420 A MONTAJE CONSULTE POR FAVOR EL DIbUJO DE VISTA EN DETALLE EN ESTE MANUAL PARA IDENTIFICAR LAS PARTES. 1. Saque la palanca de dos piezas de la caja. Coloque la parte delgada de la sección superior (13) en la sección inferior (15) y proceda a ajustar con el perno (14).
  • Page 8: Diagnóstico De Averías

    Contacta al Departamento de Garantía y Refacciones 5. El equipo aún no funciona. mencionado a continuación. GARANtíA Para mayores informes sobre la garantía, comuníquese por favor con su tienda local de partes automotrices NAPA. 791-6420 A Revised 04/08/09...
  • Page 9: Tonnes Métriques Cric Utilitaire

    • toujouRs abaisseR le cRic lentement Diamètre de la selle . . . . . . . . . . . . . . . . . .5-1/2 po et avec pRécaution.
  • Page 10: Directives D'utilisation

    MAnUel de fonctionneMent et liste de piÈces poUr 791-6420 A INSTALLATION PRIÈRE DE CONSULTER LA VUE ÉCLATÉE DU PRODUIT DANS LE PRÉSENT MANUEL AFIN D’IDENTIFIER LES PIÈCES. 1. Sortir de la boîte les deux parties du manche. Insérer la partie étroite du tube (13) dans la pièce du bas (15) et la fixer avec le boulon fourni (14).
  • Page 11: Entretien Préventif (Suite)

    5. Le cric ne fonctionne toujours pas correctement. Communiquer avec un centre de réparation autorisé apparaissant dans la liste ci-jointe. GARANtIe Pour plus de renseignements au sujet de la garantie, veuillez communiquer avec votre magasin de pièces automobiles NAPA local. 791-6420 A Revised 02/27/09...

Table des Matières