Storage And Maintenance - Chapin 8000A Instructions D'assemblage Et D'utilisation

IMPROPER USE OR FAILURE TO FOLLOW INSTRUCTIONS CAN RESULT IN
PRODUCT FAILURE OR INJURIES. FOR SAFE USE OF THIS PRODUCT YOU
MUST READ AND FOLLOW ALL INSTRUCTIONS BEFORE USING.
Assembly Instructions
Remove bolts and nuts
General Operating Instructions
• Be sure gate control is in the closed position before filling hopper
• Determine appropriate setting for material being used by reading
the suggested setting on the material's bag AND/OR by
referencing the application chart on your spreader's control panel
(Charts provided are only guidelines. Be sure to read the
instructions on the bag/box of the material you're spreading to
identify accurate setting needed)
• Remove wing nut and slide indicator to desired setting. Tighten
wing nut completely.
• To begin spreading, start walking (about 3mph pace) release the
control lever by pushing it forward. It will spring forward to the
slide stop.
• To stop spreading simply pull the gate control back into the closed
position.

Storage and Maintenance

• When finished spreading empty hopper of any remaining material
• Thoroughly wash spreader and allow to dry before storing
• To fold down handle:
- Loosen wing nuts and flip handle down
- Tighten wing nuts completely
WARNING
Flip handle up and re-attach
bolts and nuts
Completed Assembly