FITFIU FITNESS MC-260 Manuel D'instructions page 54

TROUBLESHOOTING
The following information may assist in identifying a problem and rectifying it.
Problem
Console does not work
Not all information is
displayed
Tape is not working
properly
The display shows "- - -"
The display shows "E01"
The display shows "E02"
The display shows "E03"
Cause
The plug is not connected
The switch is switched off
The pcb won't turn on or it's broken.
Signal cable is not connected
The computer is broken
Backlight is broken
IC display unit is not properly
inserted
EMI gasket slides, not properly
adjusted
The belt is too tight or too loose
The belt torsion is too large or too
small
The tape has too much resistance
Security key disconnected
No signal
Current overload
Protection overload
Connect the plug to the electrical outlet
Turn on the switch
Press overload protector or change PCB
Reconnect the signal cable or replace it
Change your computer
Check the backlight cable or replace it
Re-insert the IC and solder or replace it with
a new one.
Reassemble the display
Adjust belt tension
Setting the torsion to the correct position
Adjust tape position or add silicone oil
Put the security key
Reconnect the signal cable
Replace the signal cable
Change your computer
Install a new pcb
Disconnect the power and turn it back on
If the engine smells, change it.
If the PCB gives off an odour, change it
Disconnect the power and turn it back on
If the engine smells, change it.
If the PCB gives off an odour, change it
Adjust belt position or add oil
54
Solution