General Safety - Campbell Hausfeld CL252100AV Mode D'emploi

Operating Instructions
Please read and save these instructions. Read carefully before attempting to assemble, install,
operate or maintain the product described. Protect yourself and others by observing all safety
information. Failure to comply with instructions could result in personal injury and/or property
damage! Retain instructions for future reference.

General Safety

Information (Continued)
You can create dust when
you cut, sand, drill or grind
materials such as wood,
paint, metal, concrete, cement, or
other masonry. This dust often contains
chemicals known to cause cancer, birth
defects, or other reproductive harm.
Wear protective gear.
GeneRal saFety
This product is a part of a high pressure
system and the following safety
precautions must be followed at all times
along with any other existing safety rules.
1. Read ALL manuals included
with this product carefully.
Be thoroughly familiar with
the controls and the proper
use of the equipment.
2. ONLY persons well acquainted with
these rules of safe operation should
be allowed to use the air tool.
Do NOT exceed maximum
operating pressure of the air
tool (90 pSI). The air tool COULD explode
and result in death or serious personal
injury.
3. Do NOT exceed any pressure rating
of any component in the system.
Maximum operating pressure of 90
PSI is measured at the tool inlet while
the tool is running. The pressure drop
between the compressor and tool
needs to be compensated for at the
compressor.
2
MANUAL
www.campbellhausfeld.com
Release ALL pressure from the
system before attempting to
install, service, relocate or perform any
maintenance.
4. Disconnect air tool from air supply
when not in use and before changing
tools, attachments or performing
service.
Safety glasses and ear
protection MUST be worn
during operation.
5. Do NOT wear loose fitting clothing,
scarves, neck ties or jewelry when
operating any tool. Loose clothing
or jewelry may become caught in
moving parts and result in serious
personal injury.
6. Do NOT depress trigger when
connecting air supply hose to tool.
7. Do NOT put hands near or under
moving parts.
working in awkward positions and
repetitive work motions can cause injury
to hands and arms. Stop using any tool
if discomfort, numbness, tingling or pain
occur and consult a physician.
8. Check air hoses for weak or worn
condition before each use. Make sure
ALL connections are secure.
9. Protect air lines from damage or
puncture. Do NOT carry tool by air
hose.
10. NEVER trigger the tool when
not applied to a work object.
Attachments MUST be securely
Excessive exposure
to vibration,