Mountain Lab Gear SCOUT 2W Manuel De L'utilisateur page 9

2. When activity is detected, the radio will stop scanning and
receive the transmission. At the end of transmission, press
the PTT button within five seconds to respond. Otherwise the
radio will resume scanning.
3. If the PTT button is pressed while the device is scanning, the
transmission will be sent on the main selected channel.
4. Press the
Note: If the device stops on an unintended/undesired
transmission, press
remove that channel from the scan list by pressing and holding
or for three seconds.
To restore removed channels to the scan list, press
and re-enter scan mode.
Monitor
Monitor mode can be used to listen for weak signals or to check
activity on the current channel.
1. Press and hold
2. Release the
LED Lamp
Press the
is disabled by the keypad lock.
Weather
In weather mode, your radio can receive NOAA weather
information, warnings and alerts.
Press and hold the
exit weather mode.
button to exit scan mode.
or
for three seconds to enter monitor mode.
button to exit monitor mode.
button to turn on/off the lamp. The lamp feature
button for three seconds to enter or
to resume scan OR temporarily
to exit
8