Télécharger Imprimer la page

Furman ELITE-15 DM i Guide De L'utilisateur page 8

Masquer les pouces Voir aussi pour ELITE-15 DM i:

Publicité

Les langues disponibles

Les langues disponibles

E
-15 DM
O
'
M
litE
i
wnEr
s
anual
This would necessitate limited signal bandwidth that would not allow the signal to pass. Under extreme conditions, it is possible that
the surge suppression in one of these devices could sacrifice itself after a catastrophic event. If the telephone, cable or satellite signal
will no longer pass through our protector, please contact your local service representative, installer or Furman for servicing. Since
these circuits are modular, replacement may be accomplished in seconds with a new TVSS module. To test this, simply disconnect the
incoming and out going cable from the Elite-15 DM i. Connect the incoming connector to the component that formerly received the
out going connector, thus by-passing the in-line protection. If the signal is present (but not when used with the Elite-15 DM i) then the
protection circuit is damaged (assuming it worked properly before a storm or catastrophic event).
Warranty
Furman Sound, LLC. warrants to the original purchaser of this product, the Furman Elite-15 DM i, that the product will be free
from defects in material and workmanship for a period of three years from the date of purchase. The purchaser of the product
is allowed fifteen days from the date of purchase to complete warranty registration by mail or on-line at the Furman website. If
the purchaser fails to complete the aforementioned registration, the warranty period will be reduced to one year from the date
of purchase.
If the product does not conform to this Limited Warranty during the warranty period (as herein above specified), purchaser
shall notify Furman in writing of the claimed defects. If the defects are of such type and nature as to be covered by this
warranty, Furman shall authorize the purchaser to return the product to the Furman factory or to an authorized Furman repair
location. Warranty claims should be accompanied by a copy of the original purchase invoice showing the purchase date; this
is not necessary if the Warranty Registration was completed either by mailing in the completed warranty card or by registering
on-line at the Furman website. Shipping charges to the Furman factory or to an authorized repair location must be prepaid by
the purchaser of the product. Furman shall, at its own expense, furnish a replacement product or, at Furman's option, repair the
defective product. Return shipping charges back to purchaser will be paid by Furman.
CoNNECTED EQUIpMENT WARRANTY: Furman Sound's Connected Equipment Warranty covers equipment that is damaged
by transient voltage (an "Occurrence") while properly connected through the Furman Elite-15 DM i to a properly wired AC
power line with a protective ground in an indoor location. Furman's Connected Equipment Warranty is limited to the amount
of the deductible on the Purchaser's personal property insurance policy up to $500.00. In order to make a claim for this
Connected Equipment Warranty, the Purchaser must forward a copy of his/her personal property insurance claim for the
damaged equipment to Furman and complete the Furman Connected Equipment Warranty claim form (call Furman at (707)
763-1010 to obtain the form). Furman reserves the right to review the damaged Furman product, the damaged connected
equipment, and the site where the damage occurred. All cost of shipping damaged equipment to Furman for inspection
shall be borne solely by the Purchaser. Damaged equipment must remain available for inspection until the claim is finalized.
The Connected Equipment Warranty is also in effect for a period of three years unless the Purchaser does not complete the
warranty registration within fifteen days from date of purchase, at which time, the Connected Equipment Warranty period is
also reduced to one year from the date of purchase.
All warranties contained herein are null and void if: the Furman Surge Protector in use during the occurrence is not provided to
Furman for inspection upon Furman's request at the sole expense of the Purchaser, Furman determines that the Furman Surge
Protector has been opened, improperly installed, altered in any way or tampered with, Furman determines that the damage did
not result from the Occurrence or that no Occurrence in fact took place or Furman determines that the connected equipment
was not used under normal operating conditions or in accordance with Manufacturer's instructions for the connected
equipment. All Furman Surge Protectors must be plugged directly into a properly wired AC power line with a protective ground
and must not be "daisy-chained" together in serial fashion with other power strips, UPS's, other surge protectors, three-to-
two-prong adapters, or extension cords. Any such installation voids this warranty. The Furman warranty only protects against
damage to properly connected equipment where Furman has determined, at its sole discretion, that the damage resulted
from an Occurrence and does not protect against acts of God (other than lightning) such as flood, earthquake, war, terrorism,
vandalism, theft, normal-use wear and tear, erosion, depletion, obsolescence, abuse, damage due to low-voltage disturbances
(i.e. brownouts or sags), non-authorized program, or system equipment modification or alteration. Do not use this product
in anyway with a generator, heater, sump pump, water-related device, life support device, medical device, automobile,
8

Publicité

loading

Ce manuel est également adapté pour:

Elite-15i