Programming And Playing A Track Sequence - MC Crypt CDMPX-30 Notice D'emploi

10. Commissioning
i) Programming and playing a track sequence
You can save track sequences of up to 20 tracks.
Programming the track sequence (only with audio CDs)
• Stop CD playback by pressing the PLAY/PAUSE button
• Press the button PROG/FOLDER/ID3 (3). The display shows „P 01" (program spot 1).
• With the track skip buttons |
• Press the button PROG/FOLDER/ID3 (3). The display shows „P 02" (program spot 2).
• With the track skip buttons |
• Continue until the desired track sequence is programmed.
Playing back the programmed track sequence
• Start playback of the programmed track sequence by pressing the key PLAY/PAUSE
• With the button SINGLE/CONTINUE (4), switch the CD player to CONTINUE mode (SINGLE may not appear
on the display), otherwise the CD player always goes into pause at the start of a new track.
Quitting the track sequence playback function
• To quit playback of the track sequence, interrupt playback with the button PLAY/PAUSE
• Remove the CD from the CD compartment or turn the CD player off.
• The track sequence is deleted.
k) Turning the player off
• Interrupt CD playback by pressing the PLAY/PAUSE button
• Press the button OPEN/CLOSE (2) and remove the CD.
• Turn off the amplifier and/or mixing desks that might be connected.
• Only then switch off the CD payer with the mains switch (23).
40
(7) and/or | (8), select the first desired track.
(7) and/or | (8), select the next desired track.
|| (21).
|| (21).
|| (21).
|| (21).