Technical Specifications - Ega Master 62951 Manuel D'instructions

Accuracy
Calibration certificate
Reversible
Teeth
Individual case
- Set the torque to the lowest setting following use to relieve stress on the compressive spring.
- Only clean the unit using dry materials – do not dip it in petrol or solvent.
- Do not disassemble the wrench for any reason.
- With the exception of the ratchet mechanism, do not lubricate the wrench.
The wrench should be re-calibrated periodically. The calibration of the wrench should be
checked at least once a year, after any abnormal use or overloading, or after 5.000 cycles.
IMPORTANT!
The maker will not take responsibility for damage or malfunction as a result of the tool being
incorrectly used or, applied for a purpose for which it was not intended.
The maker guarantees to the machine owner garantie ilimitee against any manifacture defect.
This guaranteee do not cover the parts wich are consumables.
Note: to apply the guarantee its necesary to send the "GUARANTEE CERTIFICATE" duly filled
within one week after purchased the machine to the maker.

Technical specifications

MAINTENANCE AND INSPECTION
CALIBRATION
NOTES
GUARANTEE
3%
45
62951-62979
7