Axis Q1614-E Guide D'installation page 21

1
Cable gland
2
Gasket
3
Plug (discard)
4
Cap
1. Loosen the cable cover screws; detach the cable cover from the bottom cover.
2. Remove the cap, the plug and the gasket from the cable gland.
3. Route the network cable through the cap.
4. Slide the network cable through the slit on the gasket to attach the gasket to the network
cable. See Connectors on page 17 for information on network cable requirements.
5. Route the network cable through the cable gland.
6. Press the gasket into the cable gland and screw the cap on firmly.
Install the Camera on the Bracket
Note
To locate the different components see illustrations under Hardware Overview on page 10.
AXIS Q1614-E Network Camera
21