Changing The Hydraulic Oil - PRO-POINT 8662223 Manuel D'utilisateur

V1.0
BLEEDING AIR FROM THE HYDRAULIC SYSTEM
1. Remove any load from the table.
2. Lift the table to the highest position.
3. Squeeze the control lever while pumping the foot pedal to
rapidly lower the table.
4. Repeat steps 2-3 until the desired lifting speed is achieved.

CHANGING THE HYDRAULIC OIL

IMPORTANT! Change the hydraulic oil every 12 months.
1. Lift the table until the pump is easily accessible.
2. Place an approved container below the oil drain plug (#A4).
3. Remove the oil drain plug and allow oil to drain into the
approved container.
IMPORTANT! Used oil must be disposed of properly. Do not
pour it on the ground, down a drain or throw it in the trash.
Take the oil to your local recycling centre or a service station
for reclamation.
4. Fill the pump with new hydraulic oil (120 ml max).
5. Press the oil drain plug firmly into the hole.
6. Lift the table to the highest position then lower it down.
7. Wedge a flat screwdriver between the oil drain plug and
pump housing (#A5). You will hear a hissing sound, which
means air is bleeding from the hydraulic system.
8. Remove the screwdriver and reseat the oil drain plug.
9. Repeat steps 7-8 until the desired lifting speed is achieved.
CLEANING
Wipe the surface with a clean, moist cloth.
Visit www.princessauto.com for more information
500 LB HYDRAULIC LIFT TABLE CART 8662223
9