Useful Information - Chicago Pneumatic CP8818 Manuel De L'opérateur

Cordless impact wrench
Product specific instructions
Warning!
To reduce the risk of fire, personal injury, and product
damage due to a short circuit, never immerse your tool,
battery pack or charger in fluid or allow a fluid to flow
inside them. Corrosive or conductive fluids, such as sea-
water, certain industrial chemicals, and bleach or bleach-
containing products, etc., can cause a short circuit.
Battery
Battery packs which have not been used for some time
should be recharged before use.
Temperatures in excess of 50°C (122°F) reduce the perfor-
mance of the battery pack. Avoid extended exposure to heat
or sunshine (risk of overheating).
The contacts of chargers and battery packs must be kept
clean.
For an optimum life-time, the battery packs have to be fully
charged, after used. To obtain the longest possible battery
life remove the battery pack from the charger once it is fully
charged.
The battery pack has overload protection that protects it from
being overloaded and helps to ensure long life. Under ex-
treme stress the battery electronics switch off the product au-
tomatically. To restart, switch the product off and then on
again. If the product does not start up again, the battery pack
may have discharged completely. In this case it must be
recharged in the battery charger.
Maintenance instructions
• Follow local country environmental regulations for
safe handling and disposal of all components.
• Maintenance and repair work must be carried out by
qualified personnel using only original spare parts. Con-
tact the manufacturer or your nearest authorised dealer
for advice on technical service or if you require spare
parts.
• Always ensure that the machine is disconnected from en-
ergy source to avoid accidental operation.
• Disassemble and inspect the tool every three 3 months if
the tool is used every day. Replace damaged or worn
parts.
• To keep downtime to a minimum, the following service
kit is recommended : Tune-up kit
• Do not at any time let brake fluids, gasoline, petroleum
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or de-
stroy plastic which could result in serious personal in-
jury.
• Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and can be damaged by their use.
Use clean clothes to remove dirt, dust, oil, grease, etc.
Disposal
• The disposal of this equipment must follow the legisla-
tion of the respective country.
• All damaged, badly worn or improperly functioning de-
vices MUST BE TAKEN OUT OF OPERATION.
• The disposal of this equipment must follow the legisla-
tion of the respective country.
• Repair only by technical maintenance staff.
Symbols
n
0
V
-1
min

Useful information

Website
Log in to Chicago Pneumatic: www.cp.com.
You can find information concerning our products, acces-
sories, spare parts and published matters on our website.
Country of origin
Hungary
© Chicago Pneumatic - 8940172293
Remove the battery pack before starting any
work on the machine.
Please read the instructions carefully before
starting the machine.
Do not dispose of electric tools together with
household waste material. Electric tools and
electronic equipment that have reached the
end of their life must be collected separately
and returned to an environmentally compati-
ble recycling facility. Check with your local
authority or retailer for recycling advice and
collection point.
European Conformity Mark
National mark of conformity Ukraine
EurAsian Conformity Mark.
Korean Conformity Mark
Always wear goggles when using the ma-
chine.
No load speed.
Volts
per minute
Direct Current
CAUTION! WARNING! DANGER!
Regulatory Compliance Mark (RCM), Prod-
uct meets applicable regulatory require-
ments.
9