Klarstein FULL HOUSE 2.0 Mode D'emploi page 50

EN
50
The power supply must comply with national standards. The connection method is shown
below:
Electrical Safety Instructions
• If the power cord is damaged or needs to be replaced, contact the manufacturer,
customer service, or a similarly qualified person to prevent hazards.
• When connecting the product directly to the power outlet, install a multi-pin circuit
breaker with a minimum distance of 3 mm between the contacts.
• Installation must comply with national regulations.
• The power cable must not be bent or twisted.
• The power cord must be checked regularly for damage by qualified personnel.
• The yellow/green cable must be connected to the grounding cable and the
terminals of the unit.
• The manufacturer is not liable for damage caused by missing or improperly
performed grounding.
• The power outlet used for the equipment must be easily accessible at all times.
L1 - 230V
L2 - 230V
N1= Neutral Conductor