Philips 1000i Série Mode D'emploi page 8

Make sure the air purifier
•
is assembled/connected
properly after cleaning
the air quality sensor and
pre-filter or replacing the
filters.
If the air purifier will not
•
be used for a long period
of time, unplug from the
electrical outlet, clean
the appliance, air quality
sensor and pre-filter (see
'Cleaning') before storing.
Make sure that you
•
plug the appliance into
a properly connected
electrical outlet.
Always place and use the
•
appliance on a dry, stable,
level, and horizontal
surface. Make sure the air
purifier cannot be easily
knocked over by a person
or object.
Leave at least 20cm/8in
•
free space behind and
on both sides of the
appliance and leave
at least 30cm/12in
free space above the
appliance.
Do not place anything on
•
top of the appliance.
6 EN
Do not sit, stand or place
•
heavy objects on the air
purifier.
Do not place the
•
appliance directly below
an air conditioner to
prevent condensation
from dripping onto the
appliance.
Make sure all filters
•
are properly installed
before you switch on the
appliance.
Only use the original
•
Philips filters specially
intended for this
appliance. Do not use any
other filters.
Do not use the filter
•
as fuel or for similar
purposes.
Avoid knocking against
•
the appliance (the air inlet
and outlet in particular)
with hard objects.
Always lift or move the
•
appliance by the handle
on back side of the
appliance.
NEVER tilt, move or
•
attempt to change or
replace a filter while the
air purifier is operating.
Switch OFF and unplug