Zephyr Pisa ZPI-E24AG Guide D'utilisation, D'entretien Et D'installation page 8

2 4
3 2
3 6 "
DUCTING
A minimum of 6" round ducting must be used to
Always use rigid type metal ducts only. Flexible
ALWAYS, when possible, reduce the number of
transitions and turns. If a long duct run is required,
increase duct size from 6" to 7" or 8".
If turns or transitions are required: Install as far
away from opening and as far apart, between 2,
as possible.
bottom of hood should be no less than 24" and no
more than 32".
It is important to install the hood at the proper
mounting height. Hoods mounted too low could
mounted too high will be hard to reach and will
If available, also refer to range manufacturer's
height clearance requirements and recommended
i n .
" m
a x .
" m
DAMAGE-SHIPMENT / INSTALLATION:
• Please fully inspect unit for damage before
installation.
• If the unit is damaged in shipment, return
the unit to the store in which it was bought
for repair or replacement.
• If the unit is damaged by the customer,
repair or replacement is the responsibility
of the customer.
• If the unit is damaged by the installer
(if other than the customer), repair of
replacement must be made by arrangement
between customer and installer.
6
www.zephyronline.com