Installing Line In Reel-Easy String Head; Maintenance; General Maintenance - Toro 51958 Manuel De L'utilisateur

Installing Line in REEL-EASY
Head
See Figures 14 - 15.
Use .095 in./2.4 mm diameter monofilament line.
1. Stop the engine and disconnect the spark plug wire.
2. Cut one piece of line approximately 25 ft. (7.6 m) in
length.
3. Rotate knob on string head until line on knob aligns
with arrows on top of string head.
4. Insert one end of line into eyelet located on either side
of the string head and push until line comes out through
eyelet on the other side. Continue to push line through
the string head until the middle section of the line is
inside the string head and line outside the string head is
evenly divided on each side.
5. While holding the string head in one hand with your
other hand, rotate the knob on the string head to
wind the line. If using the 51958 (curved shaft), knob
should be rotated counterclockwise. If using the 51978
(straight shaft), knob should be rotated clockwise. Wind
the line until approximately 8 in. (203,2 mm) remains
protruding from the string head.

Maintenance

WARNING:
Use only Toro replacement parts when servicing
this product. Use of any other parts could create
a hazard or cause product damage.
WARNING:
Always wear eye protection with side shields
marked to comply with ANSI Z87.1, along with
hearing protection. Failure to do so could result
in objects being thrown into your eyes and other
possible serious injuries.
18
String
™
Line
Clockwise (51978
straight shaft)
WARNING:
Before inspecting, cleaning, or servicing the
machine, shut off engine, wait for all moving
parts to stop, and disconnect spark plug wire
and move it away from spark plug. Failure to
follow these instructions can result in serious
personal injury or property damage.

General Maintenance

Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, lubricant, grease, etc.
Arrows
Figure 14
Counterclockwise
(51958 curved shaft)
Eyelet
Figure 15
Operation