Meccanica Fadini Elpro S20 Mode D'emploi page 11

Elpro S20
GB
LIMIT SWITCH CONNECTIONS
Accessory
Old type limit switch NC:
New limit switches hall effect
for CORAL - VIGILO
as standard from 2019
!
New limit switches hall effect
for TALOS
as standard from 2018
!
ELECTRONIC CONTROLLER UP TO 2 AUTOMATIC BOLLARDS,
WITH OR WITHOUT LIMIT SWITCH
Electrical connections
11 12 13 14 15
11 12 13 14 15
11 12 13 14 15
55 56
+ -
55 56
+ -
11
Dip-switch setting and LED indication of functions
With the STRIP jumper inserted (as in the picture),
Elpro S40 checks cyclicly every 10 minutes that the
closing limit switches (post raised) are in the
correct position; should any of them fail to be
such, only the motor of the post not in position is
operated until this is fully up as required.
N.W.: the limit switches for not in
use bollards are to stay blank.
Do not bridge them.
With the STRIP jumper inserted (as in the picture),
Elpro S40 checks cyclicly every 10 minutes that the
closing limit switches (post raised) are in the
correct position; should any of them fail to be
such, only the motor of the post not in position is
operated until this is fully up as required.
N.W.: the limit switches for not in
use bollards are to stay blank.
Do not bridge them.
With the STRIP jumper inserted (as in the picture),
Elpro S40 checks cyclicly every 10 minutes that the
closing limit switches (post raised) are in the
correct position; should any of them fail to be
such, only the motor of the post not in position is
operated until this is fully up as required.
N.W.: the limit switches for not in
use bollards are to stay blank.
Do not bridge them.