Publicité
Step 2
å
Separate the EXTENSION SLIDES (40MC) from the EXTENSION RAILS (40MA) as shown in the upper diagram
below. Be prepared, the parts are greasy.
å
Fasten the EXTENSION RAILS (40MA) to the ENDS (A and B). Use eight SILVER 1/2" FLAT HEAD SCREWS (128S)
through holes #1 and #4.
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the
inner cartridge of the EXTENSION RAIL in to find the other hole that lines up with the hole in the END. Turn a
SCREW into this hole.
å
NOTE: The EXTENSION SLIDES will be used later for the DRAWERS.
40MC
Push the black lever in and pull the SLIDE from the RAIL.
SILVER 1/2" FLAT HEAD SCREW
(8 used for the RAILS)
1
Open end
Page 8
128S
4
3
2
2
1
B
These small holes
must be here.
2
3
4
4
4
3
427013
40MA
1
1
2
3
A
www.sauder.com/service
7
Open end
Publicité
