Publicité
Step 14
1
D547
Groove
å
Insert the DRAWER SIDES (D547 and D548) at
an angle into the slot at each end of the LOWER
DRAWER FRONT (E).
3
M63
1
M63
Surface with
HIDDEN CAM
å
Push one HIDDEN CAM (1F) into the
DRAWER BRACE (M63).
å
Fasten the DRAWER BRACE (M63) to the LOWER
DRAWER FRONT (E). Tighten one HIDDEN CAM.
Page 20
The tabs should insert freely
into the slots. Gently tilt the
DRAWER SIDES side to side
until the tabs slip into the slots.
E
D548
1F
Hidden part using
recycled material.
Color may vary.
E
2
D547
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
å
Slide the DRAWER BOTTOM (D729) into the
grooves in the DRAWER SIDES (D547 and D548)
and LOWER DRAWER FRONT (E).
4
Arrow
D547
å
Fasten the DRAWER BACK (D61) to the DRAWER
SIDES (D547 and D548) and DRAWER BRACE (M63).
Use five BLACK 1-9/16" FLAT HEAD SCREWS (30S).
å
Repeat this step for the UPPER DRAWER FRONT (D).
427013
With the palm of your hand,
tap the DRAWER BOTTOM
down into the groove.
U n fi
n i s h
s u r
e d
f a c
e
D729
E
Start each screw a few turns before
completely tightening any of them.
BLACK 1-9/16" FLAT HEAD SCREW
(10 used in this step)
D61
M63
D548
www.sauder.com/service
9
D548
30S
Be sure the
DRAWER
BOTTOM
inserts into
the DRAWER
BACK groove.
Publicité
