Nikon DSB-N1 Mode D'emploi page 15

[Note]
En
• In order to prevent the camera lens from coming in contact with the
eyepiece, make sure that the front of the camera lens is not closer than
approximately 3 mm (0.1 in) to 0 eyepiece (DS mount) insertion. (Fig. 8)
• The camera slides because of its own weight in the case of adjusting the
optical axis while the fieldscope of angled body type is in use. Therefore,
carefully handle the fieldscope so that the front of the camera lens will
not come in contact with the eyepiece or 0 eyepiece (DS mount)
insertion.
28
Attaching the shutter release base
Fig. 7
0 Note) The following steps are unnecessary if the cable release is not
used.
There are two grooves on 2 shutter release base A. Select the
correct groove where 3 attaching knob for shutter release
base A is attached, according to the camera in use. The groove
on the upper side is for J1/J2 and the one on the lower side is
for V1. (Fig. 9)
b a
Loosen 3 attaching knob for shutter release base A on 4
1.
shutter release base B, select the height of 2 shutter release
Fig. 8
A, and tighten 3 attaching knob for shutter release base A.
0
(Fig. 10)
2. Loosen c attaching knob for shutter release base B and
insert 4 shutter release base B into the recess at the bottom
of 7 camera attaching base. (Fig. 11)
Tighten c attaching knob for shutter release base B and fix
3.
4 shutter release base B to the bracket. (Fig. 11) To take out
3 mm (0.1 in)
shutter release base B, loosen c attaching knob for shutter
release base B and pull out 4 shutter release base B.
Fig. 9
En
4
2
J1/J2
V1
Fig. 10 Fig. 11
2
3
4
4
c
7
29