Philips Cellesse SenseActive Mode D'emploi page 16

Intensity
Before starting, set the
On/Off switch to the
3
2
4
preferred setting. Higher
1
5 settings will provide more
0
suction power and therefore
a more intensive massage.
We advise you to start the first treatment using Setting
1. Later, either during the first treatment or when your
skin has become used to the appliance, you can
gradually increase the intensity setting. If treatment
becomes painful, decrease the intensity. The best results
are achieved when you experience the massage as
pleasurable. Since everyone's skin is different, you will
need to discover which intensity suits you best.
Treatment
Make sure that clothes or long hairs do not get caught
between the rollers. Always tie back long hair before
you start using the appliance.
Treatment with Cellesse SenseActive must, above all, be
comfortable.
Try doing it sitting down, standing up or lying down.
Gently position the appliance
on your skin, a little above
the knee. Make sure the
On/Off switch is pointing in
the direction of the upper
part of your body.
Wait until the indicator light at the front of the
appliance comes on. This is the signal that Cellesse
SenseActive is in proper contact with the skin and is
ready for use.
Always move the appliance in one direction only:
moving upwards towards the heart.
Move the appliance slowly
and gradually from a little
above the knee to the
upper part of your thigh.
The Vacumotion massage
3
system will lift the skin,
2
4
massaging the cellulite layer
in an intensive, effective and pleasurable way.
The motor-driven rollers automatically produce the
optimum speed, so that all you need to do is let your
hand follow the movement of the appliance. A complete
16
stroke from just above the knee to the upper part of
the thigh will take approximately five seconds.
Press the Vacumotion Stop
button. The indicator light
goes out and the
Vacumotion action is
temporarily switched off.
You can then lift the appliance off your skin without
any effort. The Vacumotion Stop system is particularly
convenient when you are using the appliance at the
higher intensities.
Place Cellesse SenseActive
back onto your skin right
next to where you began
the first stroke and start
the next stroke.
Repeat this procedure until
you have treated your
entire thigh, exept the inside, with a series of slow,
upward, adjacent strokes.