Adjusting The Hand-Strap - Philips Cellesse SenseActive Mode D'emploi

Skincare
Make sure your skin is clean, dry and free of grease or
other skincare products when using the appliance. Do
not apply any creams or lotions to the skin prior to
the massage.
Of course, if you wish, you may apply a cream, lotion,
talcum powder or other type of skincare product to
your skin after using Cellesse SenseActive.
Preparing the appliance for use
Put the low-voltage
appliance plug in the socket
of Cellesse SenseActive.
Put the transformer plug in
the wall socket.
Slide your hand under the
hand-strap and hold the
appliance by clasping your
fingers around the back of
Cellesse SenseActive (with
your fingertips pointing
towards the socket for the
appliance plug: see figure). If necessary, adjust the strap
to the size of your hand.

Adjusting the hand-strap

You can adjust the strap to
1
the size of your hand. Press
the adjustment button on
the inside of the strap with
2
your thumb and push the
clasp out of the appliance.
Pull the lug at the end of
the hand-strap and remove
the pin of the strap from
its slots.
15
Press the pin into one of
L
M
the other two slots. There
S
are three settings: L for
large hands, M for normal
hands and S for small
hands.
Slide the clasp back into
the appliance until it clicks
in.
You can do the same with
the other end of the strap
to tighten or loosen the
strap even more. In this
way, you can select the strap size that fits your hand
best.