Description; Purpose; Overview; Safety - GreenWorks STG308 Manuel Opérateur

EN
1

DESCRIPTION

1.1

PURPOSE

This machine is used to cut grass, light weeds, and other
similar vegetation at or around ground level. The cutting
plane must be approximately parallel to the ground surface.
You cannot use the machine to cut or chop hedges, shrubs,
bushes, flowers and compost.
1.2

OVERVIEW

Figure 1 - 17.
Trigger
1
Lock-out button
2
Upper shaft
3
Auxiliary handle
4
Middle shaft
5
Lower shaft
6
Motor housing
7
Edge guide
8
Trimmer head
9
Guard
10
Release button
11
Positioning hole
12
Knob
13
Battery release button
14
Cut-off blade
15
Tab
16
Spool cover
17
Spool
18
Spool housing
19
Eyelet
20
Anchor hole
21
Guide slot
22
Direction of rotation
A
Best cutting area
B
Dangerous cutting area
C
2

SAFETY

Make sure that you do/obey all safety instructions.
Refer to Safety Manual.
3

INSTALLATION

WARNING
English
3.1

UNPACK THE MACHINE

Make sure that you correctly assemble the machine before
use.
• If the parts are damaged, do not use the machine.
• If you do not have all the parts, do not operate the
machine.
• If the parts are damaged or missing, speak to the service
center.
1. Open the package.
2. Read the documentation in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and package in compliance with local
regulations.
3.2

ATTACH THE EDGE GUIDE

Figure 2.
The edge guide can limit the cutting range of the machine
and decrease the risk of the damage caused by the rotating
cutting line.
1. Push the edge guide onto the trimmer head until it
engages in the slots.
2. The edge guide can be flipped up for storage.
3.3

ATTACH THE GUARD

Figure 3.
Do not touch the cut-off blade.
1. Remove the screws from the trimmer head with a Phillips
head screwdriver (not included).
2. Put the guard onto the trimmer head.
3. Align the screw holes on the guard with the screw holes
on the trimmer head.
4. Tighten the screws.
3.4

ASSEMBLE THE SHAFT

Figure 4.
Never install, remove, or adjust any part of a machine while
the machine is plugged in or running.
4
WARNING
WARNING
NOTE
WARNING
WARNING