Sommaire des Matières pour Siemens ultraSense WTXD5322US
Page 1
™ ultraSense Electric Dryers Operating, Care and Installation Instructions Model: WTXD5322US Please read instructions before using. Important: Save these instructions. ™ ultraSense Seche-linges Électriques Notice d’utilisation, de maintenance et d’installation Modèle: WTXD5322US Merci de lire les instructions avant utilisation. Important: Conserver ces instructions. ™...
Congratulations on having selected a Exceptionally quiet operation Siemens clothes dryer, the choice of Sensor controlled auto cycles Definitions those that demand exceptional drying Timed cycles performance and care from their 20, 40 and 60 minutes clothes dryer. Each dryer which leaves our factory...
GROUNDING 17. To reduce the risk of fire, clothes, 28. Do not operate this dryer until you cleaning rags, mop heads and the are sure that the dryer has been INSTRUCTIONS like which have traces of any installed according to the flammable substance, such as INSTALLATION INSTRUCTIONS This appliance must be grounded.
INSTALLATION INSTRUCTIONS Introduction Before installing the dryer Do not operate the dryer at temperatures above 104°F (40°C) and Unpacking the appliance Read these installation instructions below 41°F (5°C). Low temperatures completely and carefully. They will save affect the automatic program sequence CAUTION you time and effort and help to ensure and may prolong the drying times.
Tighten the screw (2.5 Your dryer comes with a power supply Nm) so that the ground conductor cord, CSA listed in Canada. is held securely in place. The Siemens dryer requires a 4 wire receptacle.
Grounding instruction cord This appliance must be grounded. In The Siemens dryers are intended to be 1. Remove the screws from the cover the event of a malfunction or vented outdoors. To prevent build up...
Required parts Whether connecting to an existing Exhaust air outlet on the side (optional) venting system or a new venting The parts required for the exhaust air Exhaust air outlet on the underside of the system, make sure that all ducting is system (elbows, lines, exhaust air appliance (optional) clean and free of lint.
Switch the dryer to "off". Pedestal Mounting 6. If the dryer does not work, switch the dryer to "off". If mounting the dryer on the Siemens Look in the troubleshooting pedestal (accessory no. section (page 40) of the WZ 20395) follow the instructions The dryer should be level with all supplied with the pedestal.
Panel start/stop button Buttons for options (in addition to the program if Starts, interrupts and ends the drying process. required). See page 14. delicates low temp. Press for temperature sensitive textiles (e.g. acrylic fibers). The temperature of the drying process is reduced, the drying time is extended correspondingly.
Selecting a program Using the dryer rack Summary of (Option, see page 8) instructions CAUTION Before using your dryer read and follow all installation and operating instructions. Choose an option... Preparing the dryer Check the lint filter. The filter should be cleaned before and after every drying process.
To save energy, money and time, Operate your dryer only when you are Keep flammable materials and Siemens recommends the following: at home. If you intend going on vapors, such as gasoline, away from vacation or are not using your dryer for Drain the laundry thoroughly! the dryer.
Knitted textiles (e.g. T shirts, Time programs run for a specific time (20, 40, 60 minutes). cotton jersey laundry) often shrink In the "air fluff/no heat" stage the dryer when dried for the first time. Do runs on ambient air without a heat not use the "very dry/extra dry"...
Program selection table Automatic programs regular/cotton" For cottons and coloreds made of cotton or linen. Press delicates low temp." button for temperature sensitive textiles. Automatic program For laundry, Bed linen, table linen, towels which is to be ironed which is to be ironed damp dry damp dry Bed linen and table linen, towels, T shirts, sports shirts, overalls...
Using the dryer rack The start/stop" indicator light The program starts with an starts flashing. acoustic signal (if set). (Option, see page 8) If a standard program has been Use the dryer rack to dry washable selected, the indicator lights indicate woolen textiles (e.g.
5. Place the dryer rack so that the q Directly on the dryer rack 2. Press the start/stop" button. The catches are inserted at the front in start/stop" indicator light the locating holes. illuminates. 3. If the item of clothing still contains residual moisture after the indicated drying time: q Fold the item of clothing so that...
Cleaning the bearing Wipe the housing and fascia with a soft cloth and soapy water only. shield Wipe the drum, door seal and inside of the door with a damp cloth only. Over time, fluff from the drying process collects in the bearing shield. Cleaning the lint filter A dirty filter extends the drying time and increases energy consumption.
Troubleshooting Before calling the customer service, 1. Set program selector to off". WARNING check whether you can rectify the fault 2. Turn off the circuit breaker. yourself by means of the following 3. Pull the mains plug out of the table.
LENGTH OF WARRANTY SCOPE OF WARRANTY 1 Year Full Limited Warranty Siemens will repair or replace, free of charge, any component part that is From Date of Installation* proven defective under conditions of normal home use, labor and shipping costs included. Warranty repair service must be performed by an authorized Siemens Service Center.