Table des Matières
Publicité
5½ inch (14 cm) must be provided
on this side for pipes/brackets (see
page 7).
-
Distances above the indicated
minimum dimensions reduce the
risk of mold formation behind the
appliance.
-
Additional distances reduce noise
transmission.
-
Additional distances facilitate
installation and service.
-
If the dryer is installed in a small
room, the doors of the room must
be fitted with vents of a specified
minimum size.
The dryer door is delivered with hinges
on the right. If required, the door hinges
can be switched to the left side.
If the door hinges are to be changed
over, please contact your dealer or our
customer service team (see page 20)
Electrical connection
d
WARNING
Power cord must be connected by a
qualified person only.
Connect to individual Branch
Circuit.
Do not use an adapter.
Do not use an extension cord.
Do not remove ground prong.
For CANADA
Your dryer comes with a power supply
cord, CSA listed in Canada.
The Siemens dryer requires a 4 wire
receptacle.
6
When installing the receptacle for the
dryer cord, ensure that the power
supply cord is accessible when the
dryer is in the installed position.
The power cord should only be
replaced by a qualified person. Use a
4 wire power supply cord (see
electrical connection U.S.A. below).
For U.S.A.
Your dryer comes without a power
supply cord. The power cord must
meet the following requirements:
-
UL listed in the USA
-
208 240 volt rated (minimum)
-
30 amps
-
Type SRDT or DRT (UL 2158)
-
Five feet long (minimum)
d
WARNING
Power cord must be connected by a
licensed electrician only.
Use only a U.L. approved 30 amp
power cord with strain relief clamp -
note manufacturer's instructions.
Do not plug end of power cord into
a live receptacle before connecting
power cord to appliance terminals
and closing junction/splitter box as
described below.
Do not reuse old power cord. Cord
must have closed loop or upturned
end wire terminating connectors
Do not make a sharp bend or crimp
wiring/conductor at connections.
Only a 4 conductor cord shall
be used when the appliance is
d
installed in a mobile home, in a
recreational vehicle, in a new branch
circuit installation or an area where
the local codes do not permit
grounding through the neutral.
Connecting 4 wire power supply
cord
1. Remove the screws from the cover
of the terminal block located at the
top rear of the appliance.
1 - terminal block
2 - grounding strap
3 - Angle bracket for strain relief clamp
2. Loosen the bottom screw of the
grounding strap. Place the screw
to the GROUND location.
Straighten the grounding strap and
hang loosely.
d
3. Fix the strain relief clamp to the
angle bracket. Tighten the nut.
.
4. Loosen the 2 screws labeled L and
the screw labeled N in the terminal
block. and the screw of the
GROUND terminal.
5. Thread the 4 wire cable through the
U.L. strain relief clamp.
6. Tighten the screws (2.5 Nm) of the
U.L. strain relief clamp so that the
power cord cannot be moved.
7. Attach the power cord ground
conductor (green) to the GROUND
terminal. Tighten the screw (2.5
Nm) so that the ground conductor
is held securely in place.
1
2
3
Publicité
Table des Matières
