1. Attach Connecting Plate to the Column
Insert 8 sliding nuts(I) into the slots on both sides
of each column(B) as shown in Figure Top View.
I
• Align the mounting holes on sliding nuts to the holes found on the connecting
plate as shown in the Top View illustration below. Attach the Connecting Plate(J)
to the Column(B). You will not tighten the Screws(U) in this step.
• Use the tape measure(not included) to set the distance between the bottom of
connecting plates on the column. Make sure the distance is over 570mm(22.4").
Once set, tighten the Screws(U).
Note: Leave at least 10mm gap at the top of the column for the end cap.
U
Top View
J
U
Z
2. Attach Column to the Mounting Rail
1. Lay Mounting Rails(A) and (C)on the floor with the two slots side facing upward.
2. Insert 8 Sliding Nuts(I) into 2 slots on each mounting rail as shown in Figure Side
View and position the nuts centrally on the rails.
A
B
Top View
Z
1:1
C
I
I
Side View
Note: Use the tape measure to make sure the distance shown in the illustration
below is 840mm(33") on each rail.
I
B
• Align the mounting holes on sliding nuts to the holes found on the connecting plate.
Attach the assembled column to the Mounting Rails(A) and (C) with Screws(U).
• Use the tape measure to make sure the position of mounting rails are parallel.
Z
U
Z
1:1