Télécharger Imprimer la page

Kimex 031-2200K2 Instructions De Montage page 8

Publicité

Les langues disponibles

Les langues disponibles

NOTE: Read the entire instruction manual before you start installation and assembly.
• Do not begin the installation until you have read and understood all the instructions and
warnings contained in this installation sheet. If you have any questions regarding any of
the instructions or warnings, please contact your local distributor.
• This mounting bracket was designed to be installed and utilised ONLY as specified in this
manual. Improper installation of this product may cause damage or serious injury.
• This product should only be installed by someone with good mechanical ability who has
basic building experience and fully understands this manual.
• Make sure that the supporting surface will safely support the combined weight of the
equipment and all attached hardware and components.
• Always use an assistant or mechanical lifting equipment to safely lift and position the
equipment.
• Tighten screws firmly, but do not over tighten. Over tightening can cause damage to the
items, This greatly reduces their holding power.
• This product is intended for indoor use only. Using this product outdoors could lead to
product failure and personal injury.
Required for Installation
IMPORTANT:
Ensure that you have received all parts according to the component checklist prior to installation.
If any parts are missing or faulty, contact your place of purchase for a replacement.
mounting rail
A (x1)
WARNING
column
B (x2)
mounting rail
C (x1)
equipment shelf
F (x1)
sliding nut
connecting plate
support stem
I (x38)
J (x4)
K (x2)
cable clip
cable cover
P (x4)
Q (x12)
M8x90
M8x12
T (x8)
U (x32)
M5x8
5mm Allen Key
Y (x2)
Z (x1)
Package Mx2
M5x14 (x4)
M6x14 (x4)
M-A
M-B
M8x50 (x4)
washers (x4)
M-E
base
TV bracket
D (x2)
E (x4)
adaptor bracket
camera shelf
G (x1)
H (x1)
caster
support bracket
support bracket
T-slot nut
L (x4)
M (x1)
N (x1)
end cap
end cap
R(x2)
S (x4)
M8x10
M6x12
D8washer
V (x8)
W (x4)
X (x2)
6mm Allen Key
Crescent Wrench
A1 (x1)
B1 (x1)
M6x30 (x4)
M8x30 (x4)
M-C
M-D
spacers (x8)
spacers (x8)
M-F
M-G
M-H
O (x2)

Publicité

loading