3. Install the End Cap
• Insert 2 Sliding Nuts(I) into the middle slot on each mounting rail as shown in the
illustration below and position the nuts to the ends of the rails.
• Fix the nuts using Screws(V) and Washers(X).
• Attach the End Caps(S) to the ends of the top rail. Attach the End Caps(N) to the
top of each column.
V
X
I
R
S
4. Assemble the Base
• Remove the end cap from the Support Stem(K).
• Attach column to the Foot Base(D) using support stem and Screws(T).
Note: We recommend to place an unit under each column as shown in
the illustration below when installation.
K
• Screw the lockable Caster(L) into the foot base with Crescent Wrench(B1).
• Turn the stand to upright position, using the Bubble Level(not included) to
check if the stand is even.
A1
5. Attach TV Bracket
1:1
Place the TV brackets on the back of
the display with the arrow pointing up.
D
A1
T
Note: Lock the brakes on the casters to avoid
any sudden movements during installation.
L
B1
E
TOP
√
X
X