Manual Operation; Frost Protection Function; Anti-Tilt Mechanism And Thermal Shutdown - Sygonix 1524062 Notice D'emploi

• Set the desired temperature with the buttons
display for a few seconds. The current room temperature is then displayed.
• The fan runs if heating level II or I + II are enabled. The heating level display
level. The fan continues to run for approx. 1 minute when the device is switched off or when heating level I is
enabled.
• As soon as the pre-set temperature is reached, the device switches off and the heating level display
The device switches back on again as soon as the room temperature falls 2 °C below the pre-set temperature.
b) Manual operation
• With the device on, press the button
indicator goes out and the display
• Set the temperature with the buttons
below the pre-set temperature.
• Manually select with the buttons
according to the active heating level.
• Switch to automatic operation by pressing the button
• Turn off the device with the on/off button, position O. The indicator light on the on/off switch goes out.
c) Frost protection function
• Switch the device on. Set the temperature to 5 °C with the button . As soon as the room temperature falls below
5 °C, the frost protection will activate and the indicator
• The device starts heating up on heating level I + II and turns off as soon as the room temperature reaches 5 °C.
d) Anti-tilt mechanism and thermal shutdown
• The device with castors (order no. 1524062) is equipped with an anti-tilt mechanism. If the device tips over, the
anti-tilt protection activates and the device turns off automatically. The anti-tilt protection activates when a certain
angle is reached. Set the on/off switch (15) to position O. Check the device for any damage before further use. Then
set up the device up again vertically. Set the on/off switch to I to switch on the device.
• The device switches off automatically in case of overheating. Wait until the appliance has cooled down sufficiently.
Turn on the device again after it has cooled down.
(4) or (5) a. The newly set temperature flashes on the temperature
(1), (3) or (2) to switch from automatic to manual operation. The
(8) for manual operation comes on.
or . The device turns on as soon as the room temperature falls 2 °C
and the heating levels I, II or I + II. The heating level display
again. The display
(6) lights up on the function display.
(7) shows the activated heating
goes out and the display
goes out.
lights up
goes on.
23