Installation In The Bathroom; Operation; Automatic Operation - Sygonix 1524062 Notice D'emploi

• Please note the dimensions in Fig. 1 and use the wall mount to draw two drill holes on the wall. Drill two holes in the
wall. Note the length of the dowel as well as the above dimensions.
• Insert dowels. If necessary, use a hammer. Attach the wall mount with long screws. Tighten the screws with a
Phillips screwdriver (Fig. 2).
• Hang the device on the wall bracket. Draw two bore holes through the lower wall brackets (Fig. 3). Remove the
product from the wall bracket.
• Drill the holes for the bottom wall bracket and insert the appropriate dowels (Fig. 4).
• Hang the appliance on the top wall bracket. Secure the device with two screws at the bottom wall brackets. Use a
Phillips screwdriver.
c) Installation in the bathroom
• It is recommended to install the device
with a minimum distance of 0.6 m from
showers or bath tubs for bathroom
installation. Always observe the statutory
regulations. Consult a qualified electrician
for more information.

9. Operation

Before you connect the mains plug to the mains socket, ensure that the device is switched off and the on/off switch (15)
is at position O. Connect the mains plug to a mains socket.
a) Automatic operation
• Turn on the device with the on/off switch on position I. The indicator light on the on/off switch lights up and
appears on the function display (13). The temperature display (10) flashes the pre-set temperature of 25 °C for a
few seconds. After that, the room temperature is shown on the display.
• If the room temperature is above 25 °C, the device will not heat up. If the room temperature is below 25 °C, the
unit automatically begins to heat up. The device heats up as efficiently as possible. With a temperature difference
of 1 °C, only the lowest heating level I is enabled. With a temperature difference of 2 to 3 °C, only heating level II is
enabled. With a temperature difference of more than 4 °C, both heating levels (I and II) are enabled.
22
(9)