Installation; Attach Stand With Castors (Only Order. No. 1524062) - Sygonix 1524062 Notice D'emploi

1 Button (switching auto/manual)
2 Button (heating level II)
3 Button (heating level I)
4 Button (temperature down)
5 Button (temperature up)
6 Display (frost protection mode)
7 Display (heating level display)
8 Display (manual operation)
9 Display (automatic operation)
Installation accessories
• Wall mount
• 4 x dowel
• 2 x long screw
• 2 x short screw

8. Installation

Make sure that the device is turned off before it is connected to the mains socket. The on/off switch (15)
must be at position O.
The device must be at least 70 cm from the ground and fixed to the wall. No objects such as a shelf may
be located within 1 m above the device.
Combustible or flammable materials such as curtains or other decorative fabrics must be kept at least
1 m from the front, bottom, top and sides of the device.
a) Attach stand with castors (only order. no. 1524062)
• Slide the two supplied stands at the grooves on the
bottom of the device to attach. Make sure the stands fit
correctly when attaching them.
It is recommended to slide the stands onto the
grooves from above. This makes attaching
them a little easier. To do so, place the device
with the side facing down.
• Remove the stands in the opposite direction if you want
to mount the device on a wall.
20
10 Temperature display (2-digit)
11 Air outlet (top)
12 Wall mount, top (with handle)
13 Mode indicator
14 Keypad
15 On/off switch
16 Wall bracket, bottom (on both sides)
17 Air inlet (bottom)
18 2 x foot with castors (only Order no. 1524062)