Dmx Linking - Chauvet Professional OVATION FD-205WW Guide De Référence Rapide

DMX Linking

The Ovation FD-205WW will work with a DMX controller using a 3- or 5-pin DMX serial connection. A DMX Primer is
available from www.chauvetprofessional.com.
DMX Connection
The Ovation FD-205WW uses a 3- or 5-pin DMX data connection for its DMX personalities: UNO, DOS and STD.P. See
the User Manual for information about connecting and configuring the product for DMX operation.
Master Control
The Ovation FD-205WW allows control of other Ovation FD-205WW products using a regular DMX data connection. See
the User Manual to configure for Master Control operation.
Master/Slave Connection
The Ovation FD-205WW uses the DMX data connection for its master/slave mode. See the User Manual for information
about how to connect and configure the product for master/slave operation.
RDM (Remote Device Management)
Remote Device Management, or RDM, is a standard for allowing DMX-enabled devices to communicate bi-directionally
along existing DMX cabling. Check the DMX controller's User Manual or with the manufacturer as not all DMX controllers
have this capability. The Ovation FD-205WW supports RDM protocol that allows feedback to make changes to menu
map options. Download the User Manual from
Dimmer/Zoom Control
The Ovation FD-205WW may be plugged into and controlled using a regular dimmer. In this mode, the product reacts
exactly like an incandescent product; however, the motorized zoom control on the control panel needs enough power
from the dimmer to run the motor. See the User Manual to configure Dimmer/Zoom Control operation.
Mounting
Before mounting this product, read the
mounting clamps are capable of supporting the weight of the product. For our Chauvet line of mounting clamps, go to
http://trusst.com/productcategory/truss-clamps/
Product Mounting Diagram
Ovation FD-205WW QRG Rev. 1
QUICK REFERENCE GUIDE
www.chauvetprofessional.com
Safety Notes. Use at least one mounting point per product. Make sure the
Overhead
Mounting
for more details.
Mounting Clamp
Safety Cable
Secure the safety
cable using the
passageway on the
side of the product.
EN
2