GROLAB GRONODE HW03 Manuel D'installation page 12

Once the installa on is complete, run the Once the installa on is complete, run the
EN
GroLab So ware. Insert the creden als that GroLab So ware. Insert the creden als that
you will find in the back of your GroNode. you will find in the back of your GroNode.
ES
Follow the so ware instruc ons to establish a Follow the so ware instruc ons to establish a
c connec on with GroNode.
FR
On the back of your GroNode there's also a 10 On the back of your GroNode there's also a 10
digits serial number, insert it in the so ware to digits serial number, insert it in the so ware to
automa cally locate your GroNode in the local automa cally locate your GroNode in the local
n network.
For the network connec ons to operate For the network connec ons to operate
correctly, it is necessary to have the DHCP correctly, it is necessary to have the DHCP
enabled on your router. If the DHCP is enabled on your router. If the DHCP is
d disabled, access your router using the proce-
dure established by the router manufacturer dure established by the router manufacturer
and enable the DHCP op on in the se ngs and enable the DHCP op on in the se ngs
panel. p
If the connec on problems persist, check If the connec on problems persist, check
which IP address your router assigned to the which IP address your router assigned to the
GroNode and try to access it through the GroNode and try to access it through the
d direct IP op on in the GroLab so ware.
NOTE: It is also possible to connect the GroNode
directly to the PC through the Ethernet cable. In this
case, you should configure the network adapter to use
an IP inside the default 10.0.0.1 network.
11
-
11